Menu
Cerca
Filters
Close
Menu

DMG48480F021_01WTC

Immagine di DMG48480F021_01WTC Immagine di DMG48480F021_01WTC
TFT 2.1" 480x480, Round Intelligent T5L UART COF, 350cd/m², Wide View Angle (IPS), Capacitive Touch Panel (GFF with bonding OCA)
 
 

Media

 

 

ASIC Information

 
T5L0 ASIC  Developed by DWIN. Mass production in 2020,1MBytes Nor Flash on the chip, 512KBytes used to store the user database. Rewrite cycle: over 100,000 times

 

Display

 
Color 262K colors
LCD Type IPS, TFT LCD
Viewing Angle Wide viewing angle, 85°/85°/85°/85° (L/R/U/D)
Display Area（A.A） 53.28mm (W)×53.28mm (H)
Resolution 480*480
Backlight LED
Brightness 350nit

 

Voltage & Current

 
Power Voltage 3.6~5.5V, typical value of 5V
Operation Current VCC = 5V, Backlight on,170mA
VCC = 5V, Backlight off,110mA
 
 

Interface

 
User interface 50Pin_0.5mm FPC
Baudrate 3150~3225600bps
Output Voltage Output 1;3.0~3.3 V
Output 0;0~0.3 V
Input Voltage
（RXD） 		 Input 1;3.3V
Input 0;0~0.5V
Interface UART2: TTL;
UART4: TTL;（Only available after OS configuration）
UART5: TTL;（Only available after OS configuration）
Flash 8MB
 
 

Display Connection

 

 
 

 

 
 

Accessories (Selectable in Above Menu)

 

 

 
 

DRAWING

 
 
 

External Interface

 
Pin Definition I/O Functional Description
1 5V I Power supply, DC3.6-5.5V
2 5V I
3 GND GND GND
4 GND GND
5 GND GND
6 AD7 I 5 input ADCs. 12-bit resolution in case of 3.3V power supply. 0-3.3V input voltage. Except for AD6, the rest data is sent to OS core via UART3 in real time with 16KHz sampling rate. AD1 and AD5 can be used in parallel, and AD3 and AD7 can be used in parallel, which equals to two 32KHz sampling AD. AD1, AD3, AD5, AD7 can be used in parallel, which equals to a 64KHz sampling AD; the data is summed 1024 times and then divided by 64 to obtain a 64Hz 16bit AD value by oversampling.
7 AD6 I
8 AD5 I
9 AD3 I
10 AD1 I
11 +3.3 O 3.3V output, maximum load of 150mA.
12 SPK O External MOSFET to drive buzzer or speaker. The external 10K resistor should be pulled down to the ground to ensure that power-on is low level.
13 SD_CD I/O SD/SDHC interface,The SD_CK connects a 22pF capacitor to GND near the SD card interface.
14 SD_CK O
15 SD_D3 I/O
16 SD_D2 I/O
17 SD_D1 I/O
18 SD_D0 I/O
19 PWM0 O 2 16-bit PWM output. The external 10K resistor should be pulled down to the ground to ensure that power-on is low level.
The OS core can be controlled in real time via UART3
20 PWM1 O
21 P3.3 I/O If using RX8130 or SD2058 I2C RTC to connect to both IOs, SCL should be connected to P3.2,and SDA connected to P3.3 in parallel with 10K resistor pull-up to 3.3V.
22 P3.2 I/O
23 P3.1/EX1 I/O It can be used as an external interrupt 1 input at the same time, and supports both low voltage level or trailing edge interrupt modes.
24 P3.0/EX0 I/O It can be used as an external interrupt 0 input at the same time, and supports both low voltage level or trailing edge interrupt modes
25 P2.7 I/O IO interface
26 P2.6 I/O IO interface
27 P2.5 I/O IO interface
28 P2.4 I/O IO interface
29 P2.3 I/O IO interface
30 P2.2 I/O IO interface
31 P2.1 I/O IO interface
32 P2.0 I/O IO interface
33 P1.7 I/O IO interface
34 P1.6 I/O IO interface
35 P1.5 I/O IO interface
36 P1.4 I/O IO interface
37 P1.3 I/O IO interface
38 P1.2 I/O IO interface
39 P1.1 I/O IO interface
40 P1.0 I/O IO interface
41 UART4_TXD O UART4
42 UART4_RXD I
43 UART5_TXD O UART5
44 UART5_RXD I
45 P0.0 I/O IO interface
46 P0.1 I/O IO interface
47 CAN_TX O CAN interface
48 CAN_RX I
49 UART2_TXD O UART2(UART0 serial port of OS core)
50 UART2_RXD I
SKU: DMG48480F021_01WTC
Brand: DWIN
Disponibile: Si
Si tratta dela prima recensione per questo prodotto
Kit Accessori
Prezzi per quantità
Quantità
1+
5+
10+
Prezzo
€47,50
€42,30
€38,90

Per quantita’ maggiori di 25pz prego invii la richiesta a [email protected] o chiami il +39 0332 1888005

€47,50 IVA esclusa
 
 

Media

 

 

ASIC Information

 
T5L0 ASIC  Developed by DWIN. Mass production in 2020,1MBytes Nor Flash on the chip, 512KBytes used to store the user database. Rewrite cycle: over 100,000 times

 

Display

 
Color 262K colors
LCD Type IPS, TFT LCD
Viewing Angle Wide viewing angle, 85°/85°/85°/85° (L/R/U/D)
Display Area（A.A） 53.28mm (W)×53.28mm (H)
Resolution 480*480
Backlight LED
Brightness 350nit

 

Voltage & Current

 
Power Voltage 3.6~5.5V, typical value of 5V
Operation Current VCC = 5V, Backlight on,170mA
VCC = 5V, Backlight off,110mA
 
 

Interface

 
User interface 50Pin_0.5mm FPC
Baudrate 3150~3225600bps
Output Voltage Output 1;3.0~3.3 V
Output 0;0~0.3 V
Input Voltage
（RXD） 		 Input 1;3.3V
Input 0;0~0.5V
Interface UART2: TTL;
UART4: TTL;（Only available after OS configuration）
UART5: TTL;（Only available after OS configuration）
Flash 8MB
 
 

Display Connection

 

 
 

 

 
 

Accessories (Selectable in Above Menu)

 

 

 
 

DRAWING

 
 
 

External Interface

 
Pin Definition I/O Functional Description
1 5V I Power supply, DC3.6-5.5V
2 5V I
3 GND GND GND
4 GND GND
5 GND GND
6 AD7 I 5 input ADCs. 12-bit resolution in case of 3.3V power supply. 0-3.3V input voltage. Except for AD6, the rest data is sent to OS core via UART3 in real time with 16KHz sampling rate. AD1 and AD5 can be used in parallel, and AD3 and AD7 can be used in parallel, which equals to two 32KHz sampling AD. AD1, AD3, AD5, AD7 can be used in parallel, which equals to a 64KHz sampling AD; the data is summed 1024 times and then divided by 64 to obtain a 64Hz 16bit AD value by oversampling.
7 AD6 I
8 AD5 I
9 AD3 I
10 AD1 I
11 +3.3 O 3.3V output, maximum load of 150mA.
12 SPK O External MOSFET to drive buzzer or speaker. The external 10K resistor should be pulled down to the ground to ensure that power-on is low level.
13 SD_CD I/O SD/SDHC interface,The SD_CK connects a 22pF capacitor to GND near the SD card interface.
14 SD_CK O
15 SD_D3 I/O
16 SD_D2 I/O
17 SD_D1 I/O
18 SD_D0 I/O
19 PWM0 O 2 16-bit PWM output. The external 10K resistor should be pulled down to the ground to ensure that power-on is low level.
The OS core can be controlled in real time via UART3
20 PWM1 O
21 P3.3 I/O If using RX8130 or SD2058 I2C RTC to connect to both IOs, SCL should be connected to P3.2,and SDA connected to P3.3 in parallel with 10K resistor pull-up to 3.3V.
22 P3.2 I/O
23 P3.1/EX1 I/O It can be used as an external interrupt 1 input at the same time, and supports both low voltage level or trailing edge interrupt modes.
24 P3.0/EX0 I/O It can be used as an external interrupt 0 input at the same time, and supports both low voltage level or trailing edge interrupt modes
25 P2.7 I/O IO interface
26 P2.6 I/O IO interface
27 P2.5 I/O IO interface
28 P2.4 I/O IO interface
29 P2.3 I/O IO interface
30 P2.2 I/O IO interface
31 P2.1 I/O IO interface
32 P2.0 I/O IO interface
33 P1.7 I/O IO interface
34 P1.6 I/O IO interface
35 P1.5 I/O IO interface
36 P1.4 I/O IO interface
37 P1.3 I/O IO interface
38 P1.2 I/O IO interface
39 P1.1 I/O IO interface
40 P1.0 I/O IO interface
41 UART4_TXD O UART4
42 UART4_RXD I
43 UART5_TXD O UART5
44 UART5_RXD I
45 P0.0 I/O IO interface
46 P0.1 I/O IO interface
47 CAN_TX O CAN interface
48 CAN_RX I
49 UART2_TXD O UART2(UART0 serial port of OS core)
50 UART2_RXD I
Specifiche di prodotto
Brand DWIN
Size 2.1"
Risoluzione 480x480
Area Attiva (mm) Ø53.28
Colore Full Color
Nr. Colori 262K
Sistema Operativo DGUSII OS
Alimentazione 5V
Interfaccia Display UART // CAN // PWM // AD // IO
Display IC DWIN ASIC T5L0
Angolo Visione IPS
Touch Panel Capacitive (Optical Bonding)
Temperatura O. (°C) -10~60
Preferred - Not Preferred Preferred
Download
Specifiche di prodotto
Brand DWIN
Size 2.1"
Risoluzione 480x480
Area Attiva (mm) Ø53.28
Colore Full Color
Nr. Colori 262K
Sistema Operativo DGUSII OS
Alimentazione 5V
Interfaccia Display UART // CAN // PWM // AD // IO
Display IC DWIN ASIC T5L0
Angolo Visione IPS
Touch Panel Capacitive (Optical Bonding)
Temperatura O. (°C) -10~60
Preferred - Not Preferred Preferred
Prodotti correlati
Immagine di HDL662S

HDL662S

USB-50pin Adapter Board for DWIN COF T5L UART Series
Chiedi quotazione
Immagine di HDLUSB1

HDLUSB1

USB Male - USB Male Cable, Length 50cm
Chiedi quotazione
Immagine di SD_CARD

SD_CARD

16Gb Micro SD Card with Adapter
Da €7,70 IVA esclusa
Immagine di ED4 USB

ED4 USB

DWIN Intelligent T5L USB Downloader
Chiedi quotazione
Categorie
Ultimi prodotti visti
Contatti
  • +39 0332 1888005
  • +39 0332 320856
  • Via 2 Giugno, 20 – 21022 Azzate (VA) Italy
  • Partita IVA IT02764420127
    REA di Varese 285686
    Cap.sociale interamente versato 100.000€
Informazioni
Prodotti in Vetrina
Copyright © 2025 FIRST Components. Tutti i diritti riservati
Powered by nopCommerce
Developed by Weblink
FIRST Components s.r.l.
Via 2 Giugno, 20 – 21022 Azzate (VA) Italy